My Bell Satellite TV (3100/ 4100 Digital Receiver) channels change by themselves

3100 - Digital Receiver

Steps to follow: 8

On your Satellite TV remote, press SYS INFO to display the System Information screen.
Take note of the number beside the remote address field.
Press and hold SAT until TV, VCR and AUX light up.
Release SAT. It should start to flash.
While SAT is flashing, enter any number from 1 to 16, as long as it's different from the one that is already in the remote address field.
After entering the number, press #. The SAT light will flash 3 times.
Press RECORD.
The remote address field on the system info screen should now be the same as the code entered in step 5.
Select Cancel to exit.

1. On your Satellite TV remote, press SYS INFO to display the System Information screen.

Bell Stores

Book an appointment

Mobility

Bundles

TV

Internet

Home phone

Smart Home

Support overview

Billing & Accounts

Mobility

TV

Internet

Home phone

Smart Home

My services

My bills

My profile

Small Business mobile solutions

Small business services

Medium & Large Business

Need help?

My Bell Satellite TV (3100/ 4100 Digital Receiver) channels change by themselves

3100 - Digital Receiver

1. On your Satellite TV remote, press SYS INFO to display the System Information screen.

2. Take note of the number beside the remote address field.

3. Press and hold SAT until TV, VCR and AUX light up.

4. Release SAT. It should start to flash.

5. While SAT is flashing, enter any number from 1 to 16, as long as it's different from the one that is already in the remote address field.

6. After entering the number, press #. The SAT light will flash 3 times.

7. Press RECORD.
The remote address field on the system info screen should now be the same as the code entered in step 5.

8. Select Cancel to exit.

Was this article useful?

Recently viewed articles

Need help?

My Bell Satellite TV (3100/ 4100 Digital Receiver) channels change by themselves

3100 - Digital Receiver

1. On your Satellite TV remote, press SYS INFO to display the System Information screen.

2. Take note of the number beside the remote address field.

3. Press and hold SAT until TV, VCR and AUX light up.

4. Release SAT. It should start to flash.

5. While SAT is flashing, enter any number from 1 to 16, as long as it's different from the one that is already in the remote address field.

6. After entering the number, press #. The SAT light will flash 3 times.

7. Press RECORD.The remote address field on the system info screen should now be the same as the code entered in step 5.

8. Select Cancel to exit.

Was this article useful?

Related articles

Recently viewed articles

7. Press RECORD.
The remote address field on the system info screen should now be the same as the code entered in step 5.